Installing a toilet flush may appear easy, but installing it correctly will help you avoid unnecessary problems and issues. Knowing the correct way is crucial when you want to refresh your bathroom or tackle a construction project. Also, following the manufacturer's steps will help you minimize the most common problems. For more information, you can always visit https://www.plumbersingapore.org/toilet-flush-installation/.
Here are 10 tips on how to install a toilet flush with maximum efficiency:
1. Choose the Right Flush System
The flush system we use is often overlooked but is fundamental. Selecting the proper flushing mechanism is vital in the beginning stage. Several types are available in the market: gravity-fed systems, pressure-assisted systems, and dual flush systems. Always be sure that your toilet arrangements cater to customers' needs. Dual flush systems are a fantastic alternative, allowing everyone to choose between light or full flushes. If you don't know which is perfect, check out our services and get a professional plumber at https://www.plumbersingapore.org/our-services/.
2. Deactivate the Water Supply
Switch off the water supply to your toilet before proceeding with the replacement. To deactivate, locate the shutoff values near the toilet's base and turn clockwise as a rule of thumb.
3. Take Apart the Old Flush System
Before installing the new one, the flush system that has already been installed will have to be taken apart. This step is indispensable to guarantee that no portions remain that may hinder the installation. Do the following:
· Turn off the Water Supply: To prevent flooding, first turn the water supply off.
· Drain the Tank: Start the first step by removing and cleaning the toilet and using a sponge to scrub the tank dry.
· Disconnect the Water Line: Use a wrench to detach the supply line connected to the tank's bottom.
· Remove the Tank: From the toilet tank's top portion, lift the cover, and with the wrench, unbolt the bolts securing the tank.
4. Inspect and Clean the Tank
Now that the tank is opened, it would be most appropriate to perform a visual inspection of the inside. Remove internal rusting and other minerals put in the tank to ensure the new flushing device is efficient.
5. Installing the Flush Valve
Place the flush valve at the bottom of the toilet tank inside. This component sends water to the bowl when the flush handle is pulled down. Make sure it is tightly positioned and aligned so it does not leak.
6. Install the Flush Handle
Next, install the flush handle on the tank. Ensure that the handle is correctly oriented and can move freely when pushed. Make it securely positioned and properly aligned to prevent leaks.
7. Install the Flush Mechanism
Once the valve and handle are attached, connect the flush mechanism (chain or rod) to the flush valve. Set the chain length so that when pulling the handle, the valve opens wide enough and closes securely so it does not remain open.
8. Check for Leaks
Prior to switching the water supply back on, test the flush system by filling the tank with water. Inspect the area surrounding the flush valve, handle, and joints for leaks. If you notice any leaks, carefully adjust the components to tighten them.
9. Turn the Water Back On
At this point, the water supply may be restored. The supply should be switched on, once the new water flush system has been installed and checked meticulously to ensure no leakages. Below mentioned is the procedure:
· Find the Shutoff Valve: When the water supply is switched off, the valve is generally located close to the toilet.
· Valve Rotation: Gradually rotate and turn the valve anti-clockwise so that water can enter the tank.
· Tank Filling Stage: Switch off the supply until the tank is leveled. Look for any possible leakages at the joints.
· Check the Flush: When the tank is full, lift the flush socket and observe whether everything is in working condition.
10. Adjust the Water Level
In the end, adjust the water level of the tank. In most cases, the toilet water float valve regulates the water level in the tank. Change it so that the tank is able to fill sufficiently without overflowing.